Please choose your territory and language

  • International
    • English
    • Deutsch
    • Français
    • Italiano
    • Español
  • Switzerland
    • Deutsch
    • Français
    • Italiano
  • Germany
    • Deutsch
  • Austria
    • Deutsch
  • France
    • Français
  • Italy
    • Italiano
  • Spain
    • Español
  • Benelux
    • Français
    • English
  • USA/Canada
    • English
    • Español
    • Français

Compare

Compare now

Please choose your territory and language

  • International
    • English
    • Deutsch
    • Français
    • Italiano
    • Español
  • Switzerland
    • Deutsch
    • Français
    • Italiano
  • Germany
    • Deutsch
  • Austria
    • Deutsch
  • France
    • Français
  • Italy
    • Italiano
  • Spain
    • Español
  • Benelux
    • Français
    • English
  • USA/Canada
    • English
    • Español
    • Français

TM01 sizing tool

  • 1Preparation and measuring the bike
  • 2Insert data
  • 3Show results

Set up the bike for measuring

In best case you already have a bike adjusted to your desired position. If not, a professional fitting expert will be able to give you the required measurements. To measure your bike, please follow the procedure described in the boxes, and then fill out the form (enter values in mm).

Bike preparation

To take those measurements, first place your bike on an even, horizontal ground. You need to use a vertical edge as reference: for example a plumb-line or a pole

ABottom bracket height

Measure the vertical distance between the bottom bracket axle center and the ground (BBH).

  • 1Bottom bracket center

BVertical seat height

Measure the vertical distance between the ground and the top of the saddle (VSH)

  • 1Saddle top

CArmpads reach

First measure and mark the center of your handlebar armpads.
Measure the horizontal distance from the bottom bracket to the center of the pads (RP)

  • 1Vertical reference (plumb line)
  • 2Center of the pad
  • 3Bottom bracket center

DArmpads stack

First measure and mark the center of your handlebar armpads. Measure the vertical distance from the ground to the middle and upper surface of the armpads (SP).

  • 1Pad top surface

ESaddle setback

Measure the horizontal distance from the bottom bracket to the tip of your saddle (SSB). Use a vertical edge as reference. If the saddle tip is in front of the BB, then the number is negative.

  • 1Saddle tip

This document helps you collecting the necessary data for the form in the next step

Innovation
USA/Canada, English BMC SitesFind a retailerShopContact